Friday 12 April 2013

14W CLASS A AMPLIFIER CIRCUIT USING 2N3055 SCHEMATIC DIAGRAM

14W CLASS A AMPLIFIER CIRCUIT USING 2N3055 SCHEMATIC DIAGRAM

Many early amplifiers operated in Class A, but as output powers rose above 10W the problems of heat dissipation and power supply design caused most manufacturers to turn to the simpler, more efficient Class B arrangements and to put up with the resulting drop in perceived output quality. Why Class A ? Because , when biased to class A, the transistors are always turned on, always ready to respond instantaneously to an input signal. Class B and Class AB output stages require a microsecond or more to turn on. The Class A operation permits cleaner operation under the high-current slewing conditions that occur when transient audio signal are fed difficult loads. His amplifier is basically simple, as can be seen from the block diagram.



0 comments:

Post a Comment

Note: only a member of this blog may post a comment.

    Total Pageviews